Urban Urban Jungle forum

 FAQFAQ   PretražnikPretražnik   ČlanstvoČlanstvo   Korisničke grupeKorisničke grupe   RegistracijaRegistracija 
 ProfilProfil   Privatne porukePrivatne poruke   LoginLogin 

Printing issue!

Započnite novu temu   Odgovorite na temu    Urban Jungle forum - Početna -> Razno
Prethodna tema :: Sljedeća tema  
Autor/ica Poruka

Pridružen/a: 22. 06. 2018.
Postovi: 8

PostPostano: uto lip 26, 2018 12:02 pm    Naslov: Printing issue! Citirajte i odgovorite


I have two issues with my printer one is new the other isn't. The new issue is that now when I print the edges/corners/turns of the first layer seams to curl up immediately almost like the nozzle is pulling it up as it leaves. This is so bad that when the nozzle comes back it actually 'catches' it and pulls it up a little so it sticks up. This is on a larger print, I haven't tried any smaller printers due to a priority printing 'job' I am doing. I've tried heating the table, I've double and triple checked the table level, I've tried playing with the nozzle height, I soaked the nozzle in acetone over night, nothing is working and I'm getting very frustrated to the point where I want to send it back. This print is not the first print of this part I've done, but it is the first time I've had this problem. The second problem is I can't get my printer to print raftless, every time I try it doesn't stick to the platform, any thoughts?

Any help will be apprecited.

I didn't find the right solution from the Internet.

Infographic Video Agency

Thank you.
Korisnički profil Pošaljite privatnu poruku Pošaljite e-mail
Prethodni postovi:   
Započnite novu temu   Odgovorite na temu    Urban Jungle forum - Početna -> Razno Vremenska zona: GMT + 01:00.
Stranica 1 / 1.

Ne možete otvarati nove teme.
Ne možete odgovarati na postove.
Ne možete uređivati vaše postove.
Ne možete izbrisati vaše postove.
Ne možete glasovati u anketama.

Powered by phpBB © 2001, 2002 phpBB Group
HR (Cro) by Ančica Sečan